Please note that the 3.5 inch floppies came in various capacities (the two most common were 720 KB and 1.44 MB. and you will be able to write to the floppy. If that's the case, then just put a small piece of opaque tape over the "hole" (where the slider switch was). Sometimes the little "slider switch" on 3.5" floppies were removed (to make the floppy permanently read-only). If the movable part of the tab is down, the disk is write-enabled. If the movable part of the sliding tab is up, so that there's a hole in that corner of the disk, the disk is write-protected. If you hold the disk so that the edge that goes into the drive is at the bottom, this should be in the top left corner. On one corner, there should be a sliding tab. To tell if a floppy disk is write-protected (locked), look at the underside of the disk (the part that's on the bottom when you put the disk in the drive). ![]() I assume you know this, but to make sure. I assume you are talking about the 3.5" floppies. Are you talking about 5.25" and 8" floppy discs or 3.5" floppies?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |